RICOMA TC1501 will freeze after you click the sent design from the controller using EmbroideryConnect Device

 

Solution - Apply the steps/settings specified below

 

a. Plug the EmbroideryConnect Device back to to the computer, wait for the light status to established prior to opening the EmbroideryHub 
b. Click to 'Advance Settings'
c. Enable the two boxes 'Disabled serial interface' and the 'USB drive compatibility mode' [refer to screenshot]
d Click 'Apply' and 'OK'

Once EC Device is ready, mount the device back to the RICOMA TC1501 and try to send out the design.

• Related Articles

• EmbroideryConnect Firmware - Update

  EmbroideryConnect Firmware - Current Version 1.2.0 What’s new in firmware 1.2.0 Added USB drive compatibility mode to improve connectivity with some embroidery machines. Support for Tajima machine with X16 controllers (Note for Tajima X16 controllers ...

• Embroidery Connect Device Setup Video

  Click this link to open the Video on how to setup the Embroidery Connect Device Link - Embroidery Connect Device Setup Video

• EmbroideryConnect Machines List

  The following is a list of machines known to have been tested and work without issues on EmbroideryConnect. Even though your machine is not listed it does not mean it is not supported. Generally if the embroidery machine has an native USB port it ...

• How to setup a 8 sequin per device in the palette editor post update to ES e4.5.1 R2

  Steps to Follow Open your File Explorer Locate ProgramData folder - C:\ProgramData\Wilcom\EmbroideryStudio\e4\DEFAULTS Delete the old defaults.dfl file from C:\ProgramData\Wilcom\EmbroideryStudio\e4\DEFAULTS. Then you will then be able to create up ...

• Returns and Refunds Policy for EmbroideryConnect (Commercial Edition)

  Thank you for purchasing Wilcom’s EmbroideryConnect WiFi Device (Commercial Edition). We hope you are pleased with your purchase. However, if you need to return the device due to defects, the following policy outlines the procedures for requesting a ...